7
Or, to program both a main preset and its alternate:
1. On the MasterMind, select a bank number (if needed), then select a preset number.
2. On the device you wish to control, use the front panel buttons to select which functions, loops, etc., you wish to
have active for the main preset.
3. On the device you wish to control, hold down the Write button until its LEDs flash.
4. Press the Function button to select the Alternate Preset. An “A” should appear at the left side of the display.
5. On the device you wish to control, use the front panel buttons to select which functions, loops, etc., you wish to
have active for the alternate preset.
6. On the device you wish to control, hold down the Write button until its LEDs flash.
Instant Access Mode
Instant Access Mode provides another way to control your MIDI equipment. In this mode, you have direct access to five
continuous controllers – you can use the MasterMind buttons to control individual loops on a loop switcher, control
effect parameters in a multi effects processor, or perform any other function that can be controlled by a continuous
controller message.
When Instant Access mode is enabled in Global Setup, pressing the Function button will put the Mastermind into
Instant Access mode. The display will change to indicate the Instant Access (IA) mode:
When in this mode, the MasterMind buttons perform new functions:
Buttons 1 through 5 - pressing one of these buttons will send a continuous controller message. Each button press will
toggle between on (127) and off (0) values. The LED above each button will turn on when sending an on value and will
turn off when sending an off value. The MIDI channel and CC number sent by each button are set in Global Setup mode
as parameters CC1 through CC5.
Mastermind firmware version 1.4 and later has the ability to set up IA switches as momentary or grouped. This is
described in the Global Setup section.
Please note that all continuous controllers default to off. If you wish one or more to automatically turn on when a preset
is selected, use Preset Setup to set the CC value to 127 for that controller.
Bank Up and Bank Down – In Instant Access mode, these buttons will increment and decrement the preset number
(instead of the bank number). This allows you to switch presets without leaving Instant Access mode.
Function – Pressing the Function button will exit Instant Access mode and return the MasterMind to normal operating
mode.
IA Store – If you hold the Function button down for two seconds, the MasterMind will store the current state of the five
IA buttons to memory (within the currently active preset). The next time you recall the current preset, the new IA
button states will be recalled with it. After holding the Function button for two seconds, the display will briefly display
“stor”, confirming that the IA state has been stored.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern